1. The first thing to do is to prepare faucets, hoses, gaskets, hoses and other spare parts, and check whether the spare parts to be used are impurity, so as not to wear the faucet valve core; then clean the kitchen faucet and water pipe, remove the dirt in the mounting hole.
2. Then put the copper button and rubber pad into the hose, pass one end of the hose out of the hole in the sink, connect the rubber pad to the hose, and then thread the copper wire into it.
3. Connect the hose and the faucet, and use a wrench to tighten the faucet to fix it. Finally, open the water valve to test whether there is water leakage and make corresponding treatment according to the actual situation.
4. If the installed kitchen faucet is a hot and cold water faucet, you need to pay attention to the principle of left hot and right cold, that is, the hot water connected to the left water inlet pipe, the right water inlet pipe is connected to cold water, and the two water pipes need to be well controlled. Reasonable distance; if the installed kitchen faucet is a single-hole faucet, it is necessary to fix the installation nut of the faucet to avoid loosening of the faucet; during installation, be sure to select a special angle valve, and connect the angle valve to the wall. The water outlet pipe is fixed.
The main installation methods of kitchen faucets are introduced here. I hope this article can bring necessary help for you to install and use this product.