Install a shower faucet

1. Before installing the shower, you must first drill the hole. First, according to the size of the shower to be installed, determine the position and height of the hole, and then use the impact drill to drill the hole. Pay attention to control the strength when drilling, and do not penetrate the water pipes in the wall.

2. Connect the eccentric joint with the reserved water outlet pipe, and wrap the raw material tape to prevent water leakage at the connection. The distance of the water outlet should be controlled during the installation process.

3. Assemble and connect the shower head and the water outlet pipe, mark the position where the shower needs to be fixed, and then install the fixing seat on the wall with tools such as screws. When the nozzle is connected to the water inlet pipe, it should also be wrapped with raw material tape to reduce the leakage rate at the connection.

4. Install the shower head and other components on the fixed seat. If problems such as difficult installation are found during the process, it is necessary to adjust the position of the installed eccentric joint and the fixed seat until the intact nozzle and other components can be connected. Just do it.

5. Finally, use the hose to connect the nozzle, and then make sure that the nozzle will not shake and the connection will be unstable when it is placed at the position of the top elbow.