Water Tap installation process

The installation of the faucet can be roughly divided into the following steps.

Preparation: You need to prepare the necessary tools and materials before installation, such as wrenches, rubber gaskets, faucets, water pipes, etc.

Turn off the water source: Before installation, you need to turn off the main water source or the relevant valve to ensure that the water pressure in the water pipe is released.

Disassemble the old faucet: If you want to replace the faucet, you need to disassemble the old faucet first. Disassembly requires the use of wrenches and other tools to remove the fastening nuts, and layer by layer to remove the faucet parts.

Clean the faucet installation hole: After removing the old faucet, you need to clean the faucet installation hole and the surrounding area to ensure that the new faucet can fit closely.

Install the new faucet: Place the new faucet into the installation hole and tighten the fastening nut using a wrench. When installing the new faucet, you also need to pay attention to the direction and location to ensure that the faucet is used properly.

Connect the water pipe: Connect the faucet to the water pipe and use a rubber gasket to prevent leaks.

Turn on the water source: After connecting the faucet and water pipe, turn on the water source or valve to check for leaks and ensure that the faucet is used properly.