What are the problems with damaged faucets?

1. The faucet is blocked

It may be due to the accumulation of dirt or debris on the filter screen, which may cause blockage, resulting in reduced or no water output. At this time, remove the faucet and clean the filter screen. It may also be because the water-stop disk of the faucet is blocked by debris such as sand and gravel. If it is stuck, you need to disassemble the faucet to clean it, and if the rubber pad is damaged, it must be replaced.

2. The water stop tape of the faucet is damaged

Damage to the water-stop tape will easily lead to water leakage from the faucet. First, turn the faucet counterclockwise to remove it. Turn the threaded hole outward, wrap the threaded part with water tape a few times clockwise, and then install it back after confirming that the direction of the faucet is adjusted.

3. There is noise when using

It may be caused by high water pressure or poor fixation of the hot and cold water pipes. The water supply pressure should be reduced; or check whether the water pipes and the corresponding connecting objects are in good contact and fixed in time.

4. The water temperature is difficult to adjust

At this time, the hot and cold triangle valve should be adjusted to a smaller size to balance the pressures of cold and hot water. At the same time, it is necessary to control the time for the water heater to increase the water temperature to ensure that the water temperature of the water heater can keep up with the water outlet speed.

5. The water outlet leaks

This situation is usually caused by the wear of the shaft gasket in the faucet. In this case, it is necessary to remove the handle fixed on the faucet body, take out the damaged shaft gasket for replacement, and then reinstall the handle.