Of toilet decorate lightning protection small common sense

1.Do a good job of waterproofing

Sink toilet, clean the base first, make sure the ground is dry and smooth. In the pipe wall, wall foot, Yin and Yang Angle to brush the waterproof again; Then carbon slag or ceramsite backfill; In the backfill layer cement mortar to find the slope and leveling. Finally, do roll waterproof or coating on the screed layer. After the completion of waterproof construction, all the sewers of the toilet should be blocked, and water injection test should be carried out. Check AFTER 24 HOURS, IF THE ALL ROUND METOPE OF TOILET AND GROUND DO NOT HAVE LEAKAGE PHENOMENON EXPLANATION TOILET WATERPROOF QUALITY IS VERY GOOD. Finally, stick wall tiles and joints.

2.Dry and wet separation work

The lower edge of the bath cabinet and the ground should leave the ground, because in the bathroom, there will inevitably be water, if the bath cabinet is separated from the ground, not only can make the ground clean without leaving dead corners, but also need not worry about the bath cabinet will touch water, it can be said that kill two birds with one stone.

The WATERPROOF OUTSIDE THE cabinet SHOULD BE SEPARATED from THE cabinet inside the cabinet, and the waterproof inside the cabinet cannot be ignored equally. The work of bath cabinet must be fine, to close the seam, the design of cabinet door and drawer has a lot of methods: if the cabinet door is installed on magnets and other adsorption type switch, drawer with automatic return compound spring, etc., to ensure that moisture without holes and into.

The so-called dry and wet separation is only relative, so the dry area must also pay attention to moisture-proof and anti-slip treatment.

3.Set functional areas appropriately

The washing area is generally around the face and mouth. All kinds of toothpaste, toothbrush, facial cleanser and skin care products, shower gel, razor, spare towel and so on should occupy a lot of space. If the bathroom space is relatively large, a separate storage cabinet can be designed. If the bathroom is relatively small, you can choose a face washing cabinet with enough storage space. You can reserve a socket and stand for cell phone charging near the washing table, so that you can wash your face in the morning and still answer the phone or listen to music.

Closestool AREA CLOSESTOOL AREA MUST LEAVE GOOD socket AHEAD of time, FACILITATE THE POSSIBILITY OF LATE INSTALLATION OF intelligent CLOSEstool. It is not recommended to design a wall mounted toilet. Although the wall mounted toilet is suspended on the wall, it saves space on the feeling, but the cost is very expensive and it is not easy to install the toilet seat in the later stage.

If the shower area is not willing to make a regular shower room, and want to realize the separation between dry and wet, the most convenient way is to add a shower curtain. Be sure to install water retaining strips in the shower area.

Especially in winter, every time you take a bath, you will take off your clothes under the wind and warm bath. However, you do not know where to put a pile of clothes you just took off. At this time, you need to consider the position of the dirty clothes basket. Every time the towel is used, it is troublesome to take it out to dry and then bring it back for reuse. So the towel rack of the toilet had better take heating function.